Manual de instrucciones LINKSYS WMP54G

[. . . ] ® A Division of Cisco Systems, Inc. 2. 4 GHz 802. 11g WIRELESS Model No. Wireless-G PCI Adapter User Guide WMP54G Wireless-G PCI Adapter Copyright and Trademarks Specifications are subject to change without notice. Linksys is a registered trademark or trademark of Cisco Systems, Inc. Copyright © 2005 Cisco Systems, Inc. Other brands and product names are trademarks or registered trademarks of their respective holders. [. . . ] Press the Cisco logo or Secure Easy Setup button on the wireless router or access point. When it turns white and begins to flash, click the Next button on the Setup Wizard screen. The logo or button will stop flashing on the wireless router or access point when the Adapter has been successfully added to the network. Repeat this procedure for any additional Secure Easy Setup device. NOTE: You can only add one SecureEasySetup device at a time. 7. Secure Easy Setup is now complete and a configuration profile will has been created automatically. You may save your configuration profile to a text file by clicking the Save button, or print the configuration by clicking the Print button. Click Connect to Network to connect to your network. Congratulations!Figure 4-21: Secure Easy Setup Complete Chapter 4: Using the Wireless Network Monitor Creating a New Profile 32 Wireless-G PCI Adapter Setting Up the Adapter with Available Networks If you're not setting up the Adapter with Secure Easy Setup, another method for setting up the Adapter is with the available networks listed on the Available Wireless Network screen. The available networks are listed in the table on the center of the screen by SSID. Select the wireless network you wish to connect to and click the Connect button. (If you do not see your network listed, you can click the Refresh button to bring the list up again. ) If the network utilizes wireless security, you will need to configure security on the Adapter. If not, you will be taken directly to the Congratulations screen. 1. If wireless security has been enabled on this network, you will see a wireless security screen. If your network utilizes WEP (Wired Equivalent Privacy) encryption, the WEP Key Needed for Connection screen will appear. If your network utilizes WPA-Personal (Wi-Fi Protected Access) encryption, the WPA-Personal Needed for Connection screen will appear. If your network utilizes PSK2 (Pre-Shared Key 2) encryption, the PSK2 Needed for Connection screen will appear. WEP Key Needed for Connection Select 64-bit or 128-bit. Passphrase - Enter a passphrase in the Passphrase field, so a WEP key is automatically generated. The passphrase is case-sensitive and should not be longer than 16 alphanumeric characters. It must match the passphrase of your other wireless network devices and is compatible with Linksys wireless products only. (If you have any non-Linksys wireless products, enter the WEP key manually on those products. ) WEP Key - The WEP key you enter must match the WEP key of your wireless network. [. . . ] EN 609 50 Safety Appendix H: Regulatory Information 61 Wireless-G PCI Adapter EN 300-328-1, EN 300-328-2 Technical requirements for Radio equipment. Caution: This equipment is intended to be used in all EU and EFTA countries. Outdoor use may be restricted to certain frequencies and/or may require a license for operation. Contact local Authority for procedure to follow. [. . . ]