Manual de instrucciones PHILIPS 8160XLCC

[. . . ] with Jet Clean System 8160XLCC Rechargeable Tripleheader® Cordless/Cord Razor 2 ENGLISH 4 ESPAÑOL 32 8160XLCC 4 ENGLISH ENGLISH 5 IMPORTANT SAFETY INSTRUCTIONS precautions should always When using an electric appliance, basic be followed, including the following: Read all instructions before using this appliance. DANGER of electric shock: To reduce the risk 1. Do not reach for a corded razor/Jet Clean System that has fallen into water. Do not use a razor/Jet Clean System while bathing or in a shower. Do not place or store a razor or Jet Clean System where it can fall or be pulled into a tub or sink. [. . . ] Use your new razor exclusively for 3 weeks to fully enjoy the closeness of a Philips Norelco shave. At first you may not get as close a shave as you expect, or your face may even become slightly irritated. This is normal since your beard and skin will need time to adjust. Invest 3 weeks and you'll soon experience the full joy of your new razor. Always switch Razor OFF, unplug and remove power cord before cleaning. Never clean, remove or replace head assembly while motor is on. Do not touch razor heads with hard objects as this may dent or damage precision-made slotted combs. Do not use razor if combs are damaged or broken. Facial injury may occur. 3 C 4 For optimal shaving results, replace razor heads (model #HQ9) once a year. 20 ENGLISH ENGLISH 21 Preparing Jet Clean System For Use Important Only use the razor, power plug, Jet Clean System and HQ200 cleaning solution provided to charge or clean razor. Only use a Philips Norelco `XLCC' model razor with the Jet Clean System. Other Philips Norelco`X', `XL' or`LC' model razors DO NOT work with a Jet Clean System. Empty the cleaning solution canister and thoroughly rinse the canister clean with warm water every 2 weeks. The Jet Clean System thoroughly cleans but does not disinfect your razor, therefore, do not share razor with others. The charging plug converts 100-240VAC to less than 24V DC. Place the Jet Clean System on a flat, stable surface to avoid any leakage. Be careful not to tip or move the Jet Clean System if it is filled with the cleaning solution. To avoid evaporation, do not expose cleaning solution to direct sunlight. Remove the protective razor head cap from the razor before charging or cleaning the razor in the Jet Clean System. Use this appliance for its intended household use as described in this manual. 1 Place the Jet Clean System on a flat, level surface. C Simultaneously press the buttons located on both sides of the Jet Clean System (1) and lift the appliance off the Jet Clean canister (2). Always remove appliance from canister by lifting straight up. Do not tilt Jet Clean System. 2 3 Unscrew the lid on the Jet Clean Solution bottle (Model HQ200) provided with the razor. Remove the airtight seal by lifting up the tabs on the seal. Replace lid on the bottle making sure the lid is screwed on securely. [. . . ] Do not place or store razor or Jet Clean System where it can fall or be pulled into a tub or sink, water or other liquid while plugged in. If storing razor outside the Jet Clean System, put the Protective Razor Head Cap on razor to protect heads. C Simply rinse the canister with warm water. Wipe the canister with a towel or tissue to remove excess water. C 5 Carefully lower the Jet Clean System over the canister making sure the release buttons snap back into position. Maintenance Always remove razor from the Jet Clean System before cleaning appliance. Unplug the Jet Clean System. The Jet Clean System may be wiped clean using a damp cloth. [. . . ]