Manual de instrucciones TRENDNET TEG-PCITXRL QUICK INSTALLATION GUIDE

[. . . ] Gua de instalacin rpida multilinge FRANAIS Requisitos del sistema Ranura PCI ?o superior (Windows 7) / 800MHz o superior (Windows Vista) / CPU: 1GHz ESPAOL 300Mhz o superior (Windows XP/2000/ME/98) ?Memoria: 1GB RAM o superior (Windows 7) / 512MB RAM o superior (Windows Vista) / 256MB RAM o superior (Windows XP/2000/ME/98) ?Windows 7(32/64-bit) / Vista(32/64-bit) / XP(32/64-bit) / 2000/ME/98 ? [. . . ] For Windows Vista, if the installation menu does not appear automatically, click Start, click the Start Search box, and type D:\autorun. exe where "D" in "D:\autorun. exe" is the letter assigned to your CD-ROM Drive, and then press the ENTER key on your keyboard. For Windows 2000/XP, if the installation menu does not appear automatically, click Start, click Run, and type D:\autorun where "D" in "D:\autorun. exe" is the letter assigned to your CD-ROM Drive, and then press the ENTER key on your keyboard. Windows doesn't recognize my new hardware. Verify that your computer meets the system requirements as specified in Section 1. Access your device manager to make sure the adapter is installed properly. If you see a networking device with a yellow question mark or exclamation point, you will need to reinstall the device and/or the drivers. To access the device manager on Windows 2000/XP, right-click My Computer, click Properties, click the Hardware tab, and then click Device Manager. To access the device manager on Windows 7/Vista, right-click Computer, click Properties and then click Device Manager . If the device manager fails to recognize the presence of a new networking adapter, verify that the network adapter is firmly seated in the PCI slot. Plug the adapter into another PCI slot on your computer. Windows recognizes my new hardware, but I'm unable to connect to my network. Verify that the RJ-45 Ethernet Cable is securely connected from your switch or router to your network adapter. Verify that the LEDs on your network card are lit. Verify that the TCP/IP settings are set to Obtain an IP address automatically (see the steps below). Go into the Control Panel, click Network and Internet, click Network and Sharing Center, click Change Adapter Settings and then right-click the Local Area Connection icon and then click Properties. 5 2. Click Internet Protocol Version 4(TCP/IPv4) and then click Properties. Then click on Obtain an IP address automatically. Windows Vista 1. Go into the Control Panel, click Network and Internet, click Network and Sharing Center, click Manage Network Connections and then right-click the Local Area Connection icon and then click Properties. 2. Click Internet Protocol Version 4(TCP/IPv4) and then click Properties. Then click on Obtain an IP address automatically. Windows XP/2000/2003Server 1. [. . . ] Check with you Local Authority or Retailer for recycling advice. NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER'S AUTHORITY TO OPERATE THE EQUIPMENT. ADVERTENCIA En todos nuestros equipos se mencionan claramente las caracteristicas del adaptador de alimentacn necesario para su funcionamiento. El uso de un adaptador distinto al mencionado puede producir daos fisicos y/o daos al equipo conectado. [. . . ]