Manual de instrucciones TRENDNET TFC-1000S20 QUICK INSTALLATION GUIDE

[. . . ] 2 Spefications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Ordering Information. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Antes de iniciar Contenidos del paquete Convertidor de fibra Guía de instalación rápida Alimentación eléctrica de CA (7, 5 CC, 1, 5 A) Requisitos mínimos Un ambiente donde no haya generadores de campos electromagnéticos fuertes (como motores), vibraciones, polvo o exposición directa a la luz solar. [. . . ] Distance 100M Speed (Mbps) 1000 Wavelength Fiber Port Max. Cable(/125 µm ) Distance /Connector MMF 62. 5/125µm (50µm or 62. 5µm ) 550M SC 50/125µm SMF (10µm ) SC SMF (10µm ) SC SMF (10µm ) SC Bi-directional SMF (10µm ) SC Bi-directional SMF (10µm ) SC SMF (10µm ) ST SMF (10µm ) SC Bi-directional SMF (10µm ) SC Bi-directional SMF (10µm ) SC 20 km 220M TFC-1000MSC 1300nm TFC-1000S20 1000 100M 1000 1300nm TFC-1000S50 1000 100M 1000 1300nm 50 km TFC-1000S70 1000 100M 1000 1300nm 70 km TFC-1000S10D3 1000 100M 1000 TX: 1310nm RX: 1550nm TX: 1550nm RX: 1310nm 10 km TFC-1000S10D5 1000 100M 1000 10 km TFC-1000S40D3 1000 100M 1000 TX: 1310nm RX: 1550nm TX: 1550nm RX: 1310nm 40 km TFC-1000S40D5 1000 100M 1000 40 km TFC-1000S60D3 1000 100M 1000 TX: 1310nm RX: 1550nm TX: 1550nm RX: 1310nm 60 km TFC-1000S60D5 1000 100M 1000 60 km Note: MMF (multi-mode fiber); SMF (single-mode fiber) 5 Troubleshooting Q1: After connecting the Fiber converter, the LEDs do not turn on. A1: First, check that the power outlet is receiving power. Second, make sure the power adapter is firmly connected to the Fiber converter and the power outlet. Third, make sure the Ethernet and the Fiber cables are connected. Q2: All the LEDs are on, but I can't make a connection. A2: First, verify that you are using the proper fiber cable (e. g. multi-mode fiber cable for multi-mode converter; single-mode fiber cables for single-mode converters). Second, verify that the TX and RX cables have been reverse on the opposite Fiber connection. Third, power down the fiber converters and the switches. Wait 15 seconds, then plug the switches and the fiber converters back in. Q3: What is the maximum distance that is supported by the fiber converter?A3: Please reference section 4 for distance information. If you still encounter problems or have any questions regarding the Fiber Converters please contact TRENDnet's Technical Support Department. 6 Limited Warranty TRENDnet warrants its products against defects in material and workmanship, under normal use and service, for the following lengths of time from the date of purchase. Fiber Converters 5 Year Limited Warranty If a product does not operate as warranted above during the applicable warranty period, TRENDnet shall, at its option and expense, repair the defective product or deliver to customer an equivalent product to replace the defective item. All products that are replaced will become the property of TRENDnet. Replacement products may be new or reconditioned. TRENDnet shall not be responsible for any software, firmware, information, or memory data of customer contained in, stored on, or integrated with any products returned to TRENDnet pursuant to any warranty. There are no user serviceable parts inside the product. Do not remove or attempt to service the product through any unauthorized service center. [. . . ] Check with you Local Authority or Retailer for recycling advice. NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER'S AUTHORITY TO OPERATE THE EQUIPMENT. ADVERTENCIA En todos nuestros equipos se mencionan claramente las caracteristicas del adaptador de alimentacón necesario para su funcionamiento. El uso de un adaptador distinto al mencionado puede producir daños fisicos y/o daños al equipo conectado. [. . . ]