Manual de instrucciones SAMSUNG RL33EBSW

[. . . ] - The foodstuff is in contact with the back cold resource. - The appliance is under the state of deepfreeze. Fruit box cover Fruit separation sheet Fruit box Revolving icebox Ice storage box Big bottle guard Small drawer Refrigerator emits noise - The inner items are not evenly placed. - The refrigerator is installed unevenly. - The unit is located too close to wall. [. . . ] Do not use electrical appliances inside the food storage compartments of the appliance, unless they are of the type recommended by the manufacturer. Egg guard and bottle guard Lift them up to take them down. Cabinet Lamp Replacement Draw out the plug of power supply To loose the screw behind the lamp cover. And take out lamp cover by means of unclenching along its edge with flat screw-driver. PRE-RUNNING ISSUES 1. Remove all package material and remove bottom pad before running. Make the interior and external clean with mild wet cloth ( little natural cleaner can be added to mild water). To screw out the bulb anti-clockwise. 3. Keep it ready and after 1 hour, plug in the power supply. Please refer to the upper indication and conduct relative operations. To screw in new bulb clockwise. To embed lamp cover again and fix the screw behind lamp cover. Lighting lamp specification: 220/240V, 15W , E14 4 13 MAINTENANCE AND CLEANING Interior parts Dismantle all shelves, bars, trays, covers and drawers, and clean with a warm damp cloth wiper. INSTALLATION AND PLACING NOTES The refrigerator should be placed on the flat and firm floor. In case of any unevenness, regulate the adjustable foot under the body to level the refrigerator (counterclockwise means rising). Door Seal To remove and clean the door seal, use the stick wrapped by cotton cloth to clean the notch position. If cleaned with water, then to clean it dry. leave 55 mm between the back of the unit, 55 mm between the unit and the wall and 55 mm above. Water tray Screw off the screw in the compressor cover, pull up the water tray lightly and draw it out. Fix it as before after washing. The refrigerator shall be away from hot resource and direct sunlight. Ice Making Method Water line Fill water into revolving ice box until water line arrived; place the ice box carefully to the ice-making shelf. When taking out ice, turn the revolving ice box clockwise to its end and release it. Then ice can be loosed from ice making box. Store the ice in preservation box. Don't place the refrigerator in moisture as the metal parts will get rust and impair the insulation effects. In the event of natural disasters (such as rainstorm, accidents), the submerged unit shall not be put into use until nominated SAMSUNG service center repairs it and proves that it is in good condition. Ground properly for personal safety. The refrigerator shall not be grounded via phone wire or gas pipe. NOTES To draw out the plug of power supply; To make sure no water in lamp cover; To clean with neutral cleaner(recommended) WARNING Don't press the power cord. Glass separation is moveable and very heavy. Please take care of children no touching lest injured. If the placement of refrigerator is not stable enough, it may produce abnormal noise. For first time running, it takes long time to cool down from room temperature to setting temperature. usually it stops in 3 hours and keeps normal running later. 12 5 CONTROL PANEL INTRODUCTION Standard indication Refrigerator Temperature Super Cool Button Vacation indication Freezer Temperature Super Freeze Button STORING FOODS Pack the foods with freshness reserving bags (films) or seal the food container with a lid to prevent drying or bad odor escaping. C C Hot food and drink should be cooled to the room temperature before putting into the refrigerator. Standard/Vacation Button Fridge Button Freezer Button Lock Button Super Cool indication Lock status indication Super Freeze indication The cooked and raw foods shall be placed separately. 1. For saving energy, this product has three running modes: Standard , Vacation and user setting; 1-2. [. . . ] There are 5 temperature options you may take. The temperature setting will change in cycle with key press. More are the lamps on, the temperature is lower. Some setting is confirmed and shown as the current temperature after a pause up to 5 seconds. C C Upon power supplied, all indications read as 2 seconds. [. . . ]