Manual de instrucciones SAMSUNG SV-C120UM

[. . . ] Video Cassette Recorder Owner's Manual 4HEAD Hi-Fi SV-C120UM NOM Safety Instructions RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. This symbol indicates high voltage is present inside. It is dangerous to make any kind of contact with any inside part of this product. This symbol alerts you that important literature concerning operation and maintenance has been included with this product. Note to CATV system installer: This reminder is provided to call CATV system installer's attention to Article 820-40 of the National Electrical Code (Section 54 of Canadian Electrical Code, Part I) that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building as close to the point of cable entry as practical. Caution: FCC regulations state that any unauthorized changes or modifications to this equipment may void the user's authority to operate it. [. . . ] The menu cycles through: T120, T160 or T180. Once the type of cassette is set, the VCR can display the amount of time remaining on the tape when you press the DISPLAY button (see page 17). Press the MENU button when you are finished. VCR FUNCTION SETUP Tape length: Auto play: Auto repeat: Auto power off: [T120] [ON] [OFF] [OFF] [ /] [MENU/EXIT] Auto play Access the "VCR FUNCTION SETUP" menu as described above. Press w to set the cursor to "Auto play" then press to set ON or OFF. When "Auto play" is ON, the VCR will automatically begin playing a video tape when it is inserted, as long as the safety tab of the cassette has been removed (see page 18). Press the MENU button on the remote control when you are finished. VCR FUNCTION SETUP Tape length: Auto play: Auto repeat: Auto power off: [T120] [ON] [OFF] [OFF] [ /] [MENU/EXIT] Auto repeat VCR FUNCTION SETUP Access the "VCR FUNCTION SETUP" menu. Press the w and buttons to set "Auto repeat" ON or OFF. In the VCR FUNCTION SETUP "Auto repeat" sets the VCR to play a tape repeatedly [unless a tape control is activated (stop, fast forward or rewind)] . Press the MENU button on the remote control when you are finished. Tape length: Auto play: Auto repeat: Auto power off: [T120] [ON] [ON] [OFF] [ /] [MENU/EXIT] 11 VCR Setup Auto power off Access the "VCR FUNCTION SETUP" menu. Press w and to set "Auto power off" to 1Hr or 2Hr. "Auto power off " sets the VCR to turn off automatically. Note: VCR will shut off 1 or 2 hours after last button is pressed. [ /] VCR FUNCTION SETUP Tape length: Auto play: Auto repeat: Auto power off: [T120] [ON] [OFF] [1Hr] [MENU/EXIT] VCR operation Playing a cassette 1 2 3 Load a recorded cassette. When playback starts, the VCR automatically adjusts the tracking for clear pictures and sound. To stop playback, press STOP. Instant play When the VCR has a tape loaded and power is off, simply press the PLAY button to start tape playback. You don't need to press the POWER button. 12 VCR Operation Tape Controls Play and Pause/Still Press the PLAY button on the remote control or on the front of the VCR to play a video. (If Auto play is selected and the video tape has no safety tab, it will begin playing automatically when you insert it in the VCR. ) In play or slow motion mode, press the STILL button to stop the tape on a single still frame. Press the button again to resume normal viewing or recording. (The VCR automatically stops after five minutes of slow motion or still, so that VCR heads and video tapes are not accidentally damaged. ) Fast Forward and Forward Search Press FF when the tape is stopped to fast-forward the cassette at top speed. Press FF once while a tape is playing for forward search. Press and hold to increase speed by 7 times for tapes recorded at SP speed and 21 times for tapes recorded at SLP speed. Release button to play. Rewind and Reverse Search Press Rewind when the tape is stopped to rewind the cassette at top speed. Press the Rewind button once while a tape is playing for rewind search. [. . . ] Do not put any object inside a video cassette case and do not clean inside the cassette. This can permanently damage the tape, making it unusable. Warranty Information To ensure proper warranty, please return your registration card within two weeks. Record the model number and serial number from the back of the VCR and the date of purchase in the space on the right. Keep your purchase receipt with this manual for easy reference. Model Number Serial Number Date Purchased Dealer 21 Troubleshooting Before calling for service, check this list of possible problems and solutions to see if the problem can be solved with a simple adjustment. Problem No power Possible Solution Make sure the VCR is on and plugged into an operating wall outlet. [. . . ]