Manual de instrucciones TRENDNET TEG-S80DG QUICK INSTALLATION GUIDE

[. . . ] objetos pesados encima del conmutador 1 2. Conecte un cable de red RJ-45 CAT 5e o CAT 6 del PC a un puerto Ethernet disponible en el TEG-S80Dg. 2 ESPAOL DEUTSCH FRANAIS ENGLISH 1. Conecte el Power Cord (Cable de alimentacin) en la parte trasera del TEGS80Dg y despus a la toma corriente. 3. LEDs Alimentacin elctrica Verde: Est encendido Si no est iluminado: No est encendido Enlace/ACT Verde (Slido): Enlace a otro dispositivo Verde (parpadeo): La actividad ocurre desde el enlace Si no est iluminado: No se detecta nada en el puerto DEUTSCH FRANAIS ENGLISH 100/1000Mbps ESPAOL Verde: Conexin para los puertos 1000 (Full) mbar: Conexin para los puertos 100 (Full/Half) Si no est iluminado: La conexin para el puerto es de 10(Full/Half) o no se detecta nada en el puerto 3 Technical Specifications Hardware Standards IEEE 802. 3 10BASE-T IEEE 802. 3u 100BASE-TX IEEE 802. 3ab 1000BASE-T Ethernet: 2-Pair UTP/STP CAT-3, -4, -5 Fast Ethernet: 2-Pair UTP/STP CAT-5, -5e , -6 Gigabit : 4-Pair UTP/STP CAT-5e, CAT-6 (Recommended) Ethernet: 10Mbps (half-duplex), 20Mbps (full-duplex) Fast Ethernet: 100Mbps (half-duplex), 200Mbps (full-duplex) Gigabit Ethernet: 2000Mbps (full-duplex) CSMA/CD / Star 8 x 10/100/1000 Auto-MDIX RJ-45 ports 128Kbytes 9216Kbytes 10Mbps Ethernet: 14, 880pps (packet per second) 100Mbps Fast Ethernet: 148, 800pps 1000Mbps Gigabit Ethernet: 1, 488, 000pps Automatic Update 4K entries per device 16Gbps Forwarding Capacity 3. 96W (max) Per Port: Link/ACT;100mbps/1000mbps Per Unit: Power 100-240VAC, 50/60Hz, Internal Power Supply 171 x 98 x 28 mm (6. 73 x 3. 86 x 1. 1 in. ) 450g Operating: 0 ~ 40 C (32 ~ 104 F) Storage: -10 ~ 70 C (14 ~ 158 F) Operating: 10% ~ 90% Storage: 5% ~ 90% CE, FCC Network Media Data Transfer Rate Protocol/Topology Interface Data RAM Buffer Jumbo Frame Support Packet Filtering/Forwarding Rate MAC Address Learning Filtering Table Switch Fabric Power Consumption Diagnostic LEDs Power Dimensions Weight Temperature Humidity Certifications 4 Troubleshooting After connecting the Switch to a power outlet, the LEDs do not turn on. [. . . ] The Switch was not designed to share Internet between multiple computers. You need to get an Internet router such as the TW100-S4W1CA. Where is the uplink port located on the Switch?Since all the ports on the Switch are Auto-MDIX, any of the ports can be used as an uplink port. If you still encounter problems or have any questions regarding the TEG-S80Dg please contact TRENDnet's Technical Support Department. 5 Limited Warranty TRENDnet warrants its products against defects in material and workmanship, under normal use and service, for the following lengths of time from the date of purchase. TEG-S80Dg - 5 Year Limited Warranty AC/DC Power Adapter, Cooling Fan and Power Supply carry 1 year warranty If a product does not operate as warranted during the applicable warranty period, TRENDnet shall reserve the right, at its expense, to repair or replace the defective product or part and deliver an equivalent product or part to the customer. The repair/replacement unit's warranty continues from the original date of purchase. All products that are replaced become the property of TRENDnet. Replacement products may be new or reconditioned. TRENDnet does not issue refunds or credit. Please contact the point-of-purchase for their return policies. TRENDnet shall not be responsible for any software, firmware, information, or memory data of customer contained in, stored on, or integrated with any products returned to TRENDnet pursuant to any warranty. There are no user serviceable parts inside the product. Do not remove or attempt to service the product by any unauthorized service center. This warranty is voided if (i) the product has been modified or repaired by any unauthorized service center, (ii) the product was subject to accident, abuse, or improper use (iii) the product was subject to conditions more severe than those specified in the manual. Warranty service may be obtained by contacting TRENDnet within the applicable warranty period and providing a copy of the dated proof of the purchase. Upon proper submission of required documentation a Return Material Authorization (RMA) number will be issued. An RMA number is required in order to initiate warranty service support for all TRENDnet products. Products that are sent to TRENDnet for RMA service must have the RMA number marked on the outside of return packages and sent to TRENDnet prepaid, insured and packaged appropriately for safe shipment. Customers shipping from outside of the USA and Canada are responsible for return shipping fees. Customers shipping from outside of the USA are responsible for custom charges, including but not limited to, duty, tax, and other fees. 6 WARRANTIES EXCLUSIVE: IF THE TRENDNET PRODUCT DOES NOT OPERATE AS WARRANTED ABOVE, THE CUSTOMER'S SOLE REMEDY SHALL BE, AT TRENDNET'S OPTION, REPAIR OR REPLACE. THE FOREGOING WARRANTIES AND REMEDIES ARE EXCLUSIVE AND ARE IN LIEU OF ALL OTHER WARRANTIES, EXPRESSED OR IMPLIED, EITHER IN FACT OR BY OPERATION OF LAW, STATUTORY OR OTHERWISE, INCLUDING WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. [. . . ] Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received. Including interference that may cause undesired operation. Waste electrical and electronic products must not be disposed of with household waste. Check with you Local Authority or Retailer for recycling advice. NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. [. . . ]