Manual de instrucciones TRENDNET TEW-648UB QUICK INSTALLATION GUIDE

[. . . ] Haga clic en Run Autorun. exe (sólo para Windows Vista/7). 3. Y Siga las instrucciones del InstallShield Wizard (Asistente de Install Shield). 2 FRANÇAIS ENGLISH 5. Haga clic en Yes (Sí) (Windows 2000). 5. Haga clic en Continue Anyway (Continuar de todas formas) DEUTSCH 6. [. . . ] Make sure your computer meets the minimum requirements as specified in Section 1 of this quick installation guide. You must complete the installation of the Wireless Configuration Utility (as described in Section 2) before connecting the Wireless USB Adapter to your computer. Connect the Wireless USB Adapter to a different USB port on your computer. I cannot open the Wireless Configuration Utility. Access your device manager to make sure the adapter is installed properly. If you see a networking device with a yellow question mark or exclamation point, you will need to reinstall the device and/or the drivers. To access the device manager on Windows 2000/XP, right-click My Computer, click Properties, click the Hardware tab, and then click Device Manager. To access the device manager on Windows Vista, right-click Computer, click Properties and then click Device Manager. To access the device manager on Windows 7, click on the Windows icon on the bottom left-hand corner, click Computer, click System Properties and then click Device Manager. If you still encounter problems or have any questions regarding the TEW-648UB, please refer to the User's Guide included on the Utility & Driver CD-ROM or contact TRENDnet's Technical Support Department. 7 Wireless Tips The following are some general wireless tips to help minimize the impact of interference within an environment. Assign your network a unique SSID Do not use anything that would be identifying like "Smith Family Network". Choose something that you would easily identify when searching for available wireless networks. Do not turn off the SSID broadcast The SSID broadcast is intended to be on and turning it off can cause connectivity issues. The preferred method of securing a wireless network is to choose a strong form of encryption with a strong and varied encryption key. Note: after setting up the SSID, encryption type and encryption key/passphrase, please make a note of them for future reference. You will need this information to connect your wireless computers to the wireless router/access point. Change the channel Most wireless access points and routers are defaulted to channel 6. If you have a site survey tool that will display the channels you can plan your channel selection around neighboring access points to minimize interference from them. If your site survey tool does not display the channel try using channels 1 or 11. Change the channel bandwidth If you are using an 802. 11n router or access point you can also make the following changes. Change the channel bandwidth to 20/40MHz. This will provide the highest possible performance using an 802. 11n device. [. . . ] The use of higher gain antennas may also provide the necessary coverage depending on the environment. 9 Certifications This equipment has been tested and found to comply with FCC and CE Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received. Including interference that may cause undesired operation. 017898431240668 0556-10-2375 Waste electrical and electronic products must not be disposed of with household waste. [. . . ]