Manual de instrucciones TRENDNET TEW-690AP QUICK INSTALLATION GUIDE

[. . . ] Haga clic en Setup Wizard (Asistente de configuración). 4. Haga clic en I accept the terms in the license agreement (Acepto los términos de este acuerdo de licencia), y haga clic en Next (Siguiente). 5. Conecte el cable RJ45 suministrado desde el puerto LAN de su enrutador a un puerto LAN del TEW-690AP. Luego, haga clic en Next (Siguiente). 2 6. [. . . ] The default SSID of the Access Point is TRENDnet690AP. If you have enabled any encryption on the Access Point, make sure to configure the wireless network adapter with the same security key. I am trying to connect additional wireless adapters, but I don't remember the encryption (network) key. From a wired computer, log on to the access point configuration page. I have a wireless adapter that supports WiFi Protected Setup (WPS) push button setup. How do I setup WPS between the TEW-690AP and my wireless adapter?Press on the WPS button on the front of the TEW-690AP for 10 seconds. Refer to your wireless adapters for instructions on setting up WPS. I inserted the Utility CD-ROM into my computer's CD-ROM Drive but the installation menu does not appear automatically. For Windows 7, if the installation menu does not appear automatically, click on the Windows Icon on the bottom left hand corner of the screen, click the "Search programs and files" box, and type D:\Setup. exe, where "D" in "D:\Setup. exe" is the letter assigned to your CD-ROM Drive, and then press the ENTER key on your keyboard 2. For Windows Vista, if the installation menu does not appear automatically, click on the Windows Icon on the bottom left hand corner of the screen, click on the "Start Search" box, and type D:\Setup. exe, where "D" in "D:\Setup. exe" is the letter assigned to your CD-ROM Drive, and then press the ENTER key on your keyboard. For Windows XP/2000 if the window does not appear automatically, click Start, click Run and type D:\Setup. exe where "D" in "D:\Setup. exe" is the letter assigned to your CD-ROM Drive, and then press the ENTER key on your keyboard. I do not have a DHCP server or DHCP is disabled on my network and I am unable to configure the TEW-690AP. Go to the TCP/IP settings on your computer and assign a static IP address on your computer's network adapter in the subnet of 192. 168. 10. x. Since the default IP address of the TEW-690AP is 192. 168. 10. 100, do not assign a static IP address of 192. 168. 10. 100 on your computer's network adapter. Open Internet Explorer and enter http://192. 168. 10. 100 into the address bar. I followed the Quick Installation Guide and setup a new password. When I log in to the browser configuration an access error message appears. With a pin or paperclip, press and hold the reset button for 10 second and release it. If you still encounter problems or have any questions regarding the TEW-690AP, please contact TRENDnet's Technical Support Department. 7 Wireless Tips The following are some general wireless tips to help minimize the impact of interference within an environment. [. . . ] Use the wireless adapter's site survey tool to determine the best antenna orientation for your wireless devices. Interference from devices that produce RF (radio frequency) noise can also impact your signal. Position your wireless devices away from anything that generates RF noise, such as microwaves, HAM radios, Walkie-Talkies and baby monitors. Any device operating on the 2. 4GHz frequency will cause interference. [. . . ]